Danfoss TripleLynx CN Manual de instalación descargar pdf (Pagina 225)

Solar-Log1000: Configuration at the unit

Configuring the inverter data (Basic/Inverter)

Solar-Log

1000/500/200

Installation 225 of 268

Entering a pulse factor (only or S0 meter)

In the standard setting, Solar-Log™ sends 1000 pulses/kWh over the S0 out-

put. The pulse factor of the Solar-Log™ dRS-485 communications package

must be adapted to the pulse factor of the connected meter.



Note

The pulse factor of Solar-Log

1000

and of the S0 meter must be set to the same

value.

Procedure

In order to change the pulse factor:

1 Touch the number box beside Pulse factor

 The virtual keyboard is opened.

2 Enter the desired pulse factor and confirm with OK

3 Touch Save, then Next to go to the next dialogue.

Setting the S0 meter

This subdialog box is available only if a current meter is connected to Solar-

Log

1000

and has been selected.

Dialogue boxes

 The S0 meter is flexible and can be set in 3 modes:

– in Inverter mode for inverters with data protocols that are not supported

– as Overall yield meter to count the total output from the entire system

– as Consumption meter to calculate the system's own consumption rate

 Connect. module power

A value for the connected module power is needed in inverter mode, in or-

der to make power comparisons between the different inverters and offset

them against each other.

 Module field (1-9)

In the module field, the same types of strings are placed together for sys-

tem monitoring and to be monitored together. For a roof with equal mod-

ules, which have the same alignment and the same angle of inclination on

the roof, all strings are assigned to module field “1”. If there are other in-

verters connected, which are operating with a different roof alignment,

these strings are given the module field number “2”. etc.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 267 268

Sin comentarios

Danfoss TripleLynx CN Manual de instalación Pagina 225