Danfoss TripleLynx CN Manual de instalación descargar pdf (Pagina 109)

Connecting the inverters

Siemens

Solar-Log

1000/500/200

Installation 109 of 268

Connecting the inverters to each other (Solar-Log

500

, Solar-Log

1000

)

 Connection using your own fabricated daisy chain cable.

 Where to connect: X2 connection socket on outside of the inverter.

Procedure

1 Insert the plug into socket X2 on inverter 1.

2 Insert the other end of the wire into the X2 socket on inverter 2.

3 Connect the other inverters to each other in the same way.

4 Terminate in the last inverter in accordance with the inverter instructions.

Allocating communication address

 Recommendation: Continuous numbering starting with 1.

 Default settings on the inverter: Communication address 1

 Setting: Using the inverter operating display

Notes

– From the Communication/RS485 menu select Address for ProLog

– From the Communication menu set Protocol type COM 1 to 9.

 Procedure: As set out in the inverter's instructions

4.52 Siemens

Overview

 Interface integrated

 Where to connect: RS485 socket on the bottom of the inverter

 2 pin wiring

 Communication address must be allocated.

 Work steps

• Switch off the inverters and the SolarLog™; ( Page 17)

• Connect inverters to the Solar Log™

• Connect the inverters to each other

• Allocate communication address

Connecting inverters to the Solar-Log™

To connect the Solar-Log™ and the inverters prepare cables with the follow-

ing pin allocation.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 267 268

Sin comentarios

Danfoss TripleLynx CN Manual de instalación Pagina 109