Danfoss TripleLynx CN Manual de instalación descargar pdf (Pagina 152)

Configuration at a PC

Configuring network settings (Basic/Lan)

152 of 268 Solar-Log

1000/500/200

Installation

“analogue modem” section (Solar-Log

1000

analogue modem package)

If internet access by analogue modem has been selected, the access data of

the telephone service provider must be entered here.

 Internet-by-call No., user name, password

This is preset to Internet-by-call access through Arcor, but can be modified

as necessary.

 Preset “0”.

In certain telephone systems, a “0” has to be dialled before dialling the ac-

tual telephone number.

 Dial tone Off

In a standard modem, the dialling process is audible; this provides a good

initial testing function until the connection is established. The dial tone can

then be switched off.

If there are problems with the internet connection, the best solution is to

check the line with a conventional telephone to determine whether the tel-

ephone connection is working or is disconnected. In this way, you can find

out quickly and easily whether it is necessary to predial “0”.

Note: You should ensure that the telephone system allows charge group

0190.. numbers.

 Allow dial in

Solar-Log

1000

generally allows dial up if an analogue modem is used.

This means that the Solar-Log

1000

can be dialled up from outside using a

PC and another modem, if this has been enabled.

 Dial in password

The password is “solarlog”, but this should be changed.

1 If the default Internet-by-call access is to be changed:

Enter the above data

2 Click on Save

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 267 268

Sin comentarios

Danfoss TripleLynx CN Manual de instalación Pagina 152