Danfoss TripleLynx CN Manual de instalación descargar pdf (Pagina 220)

Solar-Log1000: Configuration at the unit

Solar-Log1000 WiFi: WLAN configuration (Basic/WLAN)

220 of 268 Solar-Log

1000/500/200

Installation

4 Touch Test transmission

 A window opens and shows the reception quality:

5 Touch Back to exit the test window

6 Touch Save, then Next to go to the next dialogue.

IP settings for WLAN operation

Dialogue boxes

 obtain automatically (DHCP)

The IP address can be obtained automatically if Solar-Log

1000

is connected

to an internet router which allows the DHCP service.

After saving and the automatic restart, the new IP address is displayed.

The Solar-Log

1000

can now be reached at this address and it has automatic

access to the internet.

All routers usually have the DHCP service enabled as the default setting,

so that all the subsequent data are entered automatically:

– IP Address, Subnet Mask

Here, the IP address and Subnet mask of the Solar-Log

1000

can be

configured if necessary.

However, all routers with the DHCP service enabled are preset so that

this data is entered automatically:

The factory setting of the address is 192.168.178.49, and can be

adapted only through a direct PC connection, or through a router with-

out the DHCP service, in order to allow access from a PC.

In this case, please consult a network specialist who can assign a suit-

able network address, make the other gateway settings and so on.

– Gateway

The gateway is the router to which Solar-Log

1000

is connected. Its IP

address is entered here automatically, if the DHCP service is enabled

on the router.

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 267 268

Sin comentarios

Danfoss TripleLynx CN Manual de instalación Pagina 220