Danfoss DLX 4.6 Guía de usuario descargar pdf (Pagina 67)

User Guide DLX Series L00410623-1 67

6.3.1.1. IP Address

The computer’s and the inverter’s IP address must be in the same range. If the inverter’s IP

address is 192.168.10.X, the computer’s IP address must be 192.168.10.Y, where X and Y are

different numbers between 1 and 254.

Inverter

The inverter’s default IP address is 192.168.10.20. To change the IP address, go to

Setup>Network Setup and set the inverter’s IP address as required.

To connect the PC and the inverter, the inverter’s IP address must be entered into the PC

web browser address line.

Computer

The example below shows the steps to be followed on a Windows® 7* computer to

manually change the computer’s IP address. This procedure may vary on computers with

operating systems (OS):

1. Open the network menu by clicking Start

2. Click Control Panel > Network and Sharing Center

3. Click Local Area Connection > Properties

4. Select Internet Protocol Version 4 (TCP/IPv4) > Properties

5. Select Use the following IP address

Enter the default parameters: IP address 192.168.10.10, subnet mask 255.255.255.0.

Click OK and OK

*Windows is a registered trademark of Microsoft Corporation in the United States and other countries.

6.3.2. With a Network

If a network is present, the availability of DHCP (Dynamic Host Configuration Protocol) can

determine the configuration between the inverter and the computer. With DCHP, a router

or a switch normally distributes the needed parameters (IP address and Subnet Mask) for

devices to operate in the network.

Figure 6.3.2:Connection with network and World Wide Web

1. Follower inverter

2. Master inverter

3. CAN bus cable

4. Ethernet cable

5. Router/Switch

6. World Wide Web

7. Computer

8. RS-485 cable

9. Data logger

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 85 86

Sin comentarios

Danfoss DLX 4.6 Guía de usuario Pagina 67