Danfoss VLT 8000 AQUA Instrucciones de operaciones descargar pdf (Pagina 13)

MG.60.N2.02 - VLT is a registered Danfoss trademark

VLT

5000 / VLT

6000 HVAC / VLT

8000 AQUA

Installation Instructions

1. Access to

Control

Card

Cassette

• Remove control wiring by unplugging

connector terminals (A).

• Remove grounding clamps (B) by

removing two screws holding each in

place. Save screws for reassembly.

• Loosen two captive screws (C) securing

cassette to chassis.

2. Disconnect

Control

Card

Cassette

IP20/NEMA 1 and Bookstyle

• Remove Local Control Panel (LCP) by

pulling out from top of display (A) by

hand. LCP connector on panel back

will disconnect.

• Remove protective cover by gently

prying with a screw driver at notch (B)

and lift cover out of guide pin fittings.

IP54/NEMA 12

• Open front panel of drive by loosening

captive screws and swing open.

• Disconnect Local Control Panel (LCP)

cable from drive control card.

(A)

(B)

(A)

(B)

(C)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Sin comentarios

Danfoss VLT 8000 AQUA Instrucciones de operaciones Pagina 13