Danfoss RZ1 Manual de usuario descargar pdf (Pagina 8)

RZ1 AND RZ1HP

4.0 Connecting devices to the RZ1

To establish a connection with another Z-Wave enabled unit (i.e. RET

BZ), the RZ1 must be placed into its PROGRAMME MODE.

Once the RZ1 is in PROGRAMME MODE, each channel will present

whether it has an existing binding in the following way:

Channel LED RED = unbound/no device present.

Channel LED OFF = Channel successfully bound/ device located and

communication established.

To establish communication and bind a device to the RZ1:

1. Press and release PROG button. The PROG LED will light up

RED.

2. Channels with no devices bound will show RED LED as well.

3. Press the button for the channel you wish to bind, the LED will

ash RED slowly.

4. Press the ‘include initiator’ button on the wireless device to be

connected to the RZ1 (On some devices you may need to press

and hold the include initiator button for up to 10 seconds).

5. Once binding has nished the LED for the channel just bound

will go out indicating success. If there was an error in the binding

process the PROG LED will ash ORANGE rapidly. If this occurs

acknowledge the error by pressing the PROG button and return

to step 1 to begin the process again.

6. Press PROG to return to normal operating mode (PROG LED

shows GREEN).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Danfoss RZ1 Manual de usuario Pagina 8