Danfoss RZ1 Manual de usuario descargar pdf (Pagina 11)

Danfoss Heating

6. If this process fails then the RZ1 PROG LED will ash ORANGE

fast. To acknowledge this press the PROG button. The LED will

return to RED, indicating that it has returned to programme

mode.

7. In the event of the RZ1 failing to join an existing network as a

secondary controller, the RZ1 will need to have its home and

node ID reset back to their default conditions by carrying out

a complete system reset by following the process laid out in

section 7.

4.5 Excluding the RZ1 as a secondary controller

to a network

To exclude your RZ1 from a network where it has been added as a

secondary controller, follow the steps below:

1. Place the RZ1 into programme mode by pressing the PROG

button (Programme LED will turn RED).

2. Activate the exclude/unbind initiator on the primary controller

in the network.

3. Press and hold the programme and channel buttons until the

RED LED ashes slowly indicating that exclusion as a secondary

controller has been initiated.

4. The RZ1 will attempt to unbind from the network.

5. Once the RZ1 has successfully been excluded from the network,

endpoint information and channel information will be removed

and the programme LED will return to its continuously on RED

state.

6. If a failure to exclude/unbind the RZ1 from the network occurs,

the programme LED will ash ORANGE fast. Acknowledge this

by pressing the programme button. Endpoint information and

channel information will be removed. And the channel LED will

return to a RED LED ON, indicating that it has returned to the

awaiting command programme mode.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Danfoss RZ1 Manual de usuario Pagina 11