Danfoss Стальной клапан для конвекторов однотрубных систем Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Radiadores Danfoss Стальной клапан для конвекторов однотрубных систем. Инструкция по эксплуатации Danfoss Стальной клапан для конвекторов однотрубных систем отопления Manual de usuario

Installation Guide

Steel Valve for Convectors in One-pipe Heating Systems

Danfoss Heating VIFOD102 Department

Note!

Valve body and insert should always be handled with utmost care.

Keep in original packing until ﬁnal use. Any damage may result in

malfunction of the valve.

Max.

70°C

Min. 120 mm

1. Lubricate valve insert by dipping in water. 2. Apply insert to housing and tighten by hand. Be aware of the

max. temperature, not to destroy the o-ring when applying the

insert.

x 12

30 N

30.4 ± 0.4 mm

3. Tighten insert with a 21M spanner, torque 30 Nm ± 10%. 4. To ensure closing measure of the valve, load the spindle with a

force of 30 N until stop, and measure as shown.

A special tool for control is available.

5. A leak test has to be carried out according to procedures stated

by the convector manufacturer.

6. Fit green protection cap and tighten by hand.

1 2

1Installation GuideSteel Valve for Convectors in One-pipe Heating SystemsDanfoss Heating VIFOD102 DepartmentNote!Valve body and insert should always

Внимание!Соблюдайте максимальную аккуратность при обращении с корпусом клапана и клапанной вставкой. До использования по назначению клапанные вставк

Sin comentarios