Danfoss living connect Manual de servicio descargar pdf (Pagina 2)

Actuators report change of status back to controller

Sensors report change of status of measured values to controller

Sensors directly control actuators

Actuators control other actuators

Remote controls send signals to static controllers to trigger scenes or other actions

Remote controls control other actuators.

There are two different role a controller can have. There is always one single primary controller that is managing the

network and including/excluding devices. The controller may have other functions - like control buttons - as well. All other

controllers don't manage the network itself but can control other devices. They are called secondary controllers. The

image also shows that its not possible to operate a sensor just from a remote control. Sensors only communicate with

static controllers.

Product description

Living Connect is a Z-Wave controlled electronic radiator thermostat. It is mounted on wall heating valves

and controls them by a motor. The device accepts a setpoint that is either set manually using buttons on the

device or wirelessly using Z-Wave. Afterwards, the device will regulate the warm water supply to the wall

radiator and compare the detected temperature to ensure, that the temperature in the room is kept at the

desired level. A small LCD panel on the device displays the setpoint temperature on request.

The device has an internal scheduler, that allows to define up to 9 setpoints for up to 7 week days. Once

programmed, these setpoints will be activated without any further manual or wireless interaction. Beside

setting a desired temperature the device will support special heating schemes, such as energy saving and

frost protection and intelligent functions such as detection of open windows or a valve training function to

ensure that valves are still operational after longer periods.

The living connect can be mounted to valves with standard M30x1.5 connector or RA2000 (Danfoss snap in).

Batteries

The unit is operated by batteries. Use only batteries of correct type. Never mix old and new batteries in the

same device. Used batteries contain hazardous substances and should not be disposed of with household

waste!

Battery Type: 2 * AA

Installation Guidelines

Installation

1 2 3 4 5 6 7

Sin comentarios

Danfoss living connect Manual de servicio Pagina 2