Danfoss C67 Guía de usuario descargar pdf (Pagina 65)

The grey

side of the

ECL Card

Extended service

32s

Service parameter(s) 195

195 Temperature at DHW charging, cut-in temperature

diﬀerence - upper tank temperature sensor

Circuit Setting range Factory setting

I 1 ... 30 K 20 K

The diﬀerence between the desired charging temperature and

cut-in temperature (charging start).

Set the diﬀerence.

Example:

Desired charging temperature

(section 3) 70 °C

Cut-in diﬀerence 20 K

Calculated cut-in temperature

(70-20) = 50 °C

One sensor (S6)

Temp.

Cut-out diﬀerence - line 194

Cut-in diﬀerence - line 195

Cut-out

Time

Desired charging

temp.

Cut-in

If only one sensor is installed (S6), it will measure the cut-out

temperature as well as the cut-in temperature.

Two sensors (S5 + S6)

Temp.

Cut-out diﬀerence - line 194

Cut-in diﬀerence - line 195

Cut-in

Cut-out

Time

Desired charging

temp.

The DHW temperature will vary between the cut-in and the cut-

out temperatures.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 83 84

Sin comentarios

Danfoss C67 Guía de usuario Pagina 65