Danfoss 102E7 Manual de usuario descargar pdf (Pagina 4)

Installation

NB. For FRU units - go straight to point 6 below.

1. Loosen the ﬁ xing screw in the base of the unit to release

the Wiring Cover.

2. Holding the unit face downwards, press ﬁ rmly in the

centre of the wallplate and slide it apart and lift it from

the module.

3. Fix the wallplate and terminal block to the wall, or

plaster box, as required. Ensure that the screw heads

do not protrude beyond the vertical centre rib of the

wallplate, or this will prevent the module correctly

locating onto the wallplate.

4. Surface cables can only enter from below the unit. Cut

an appropriate cable aperture in the wiring cover. If the

wallplate is mounted on a plaster box, cables can enter

from the rear below the terminal block.

Installation

Screw ﬁ xing holes

(screwheads MUST

NOT protrude

above centre rib)

Vertical centre rib

Wallplate & Terminals

1 2 3 4 5 6 7 8 9 ... 23 24

Sin comentarios

Danfoss 102E7 Manual de usuario Pagina 4