
2 Manual RS8DY302 © Danfoss 07-2005 EKC 102
Introduction
Application
• The controller is used for temperature control refrigeration appli-
ances and cold room
• Defrost control
• For front panel mounting
Principle
The controller contains a temperature control where the signal
can be received from one temperature sensor.
The sensor is placed in the cold air flow after the evaporator or in
the warm air flow just before the evaporator.
The controller controls the defrost with either natural defrost or
electric defrost. Renewed cutin after defrost can be accomplished
based on time or temperature.
A measurement of the defrost temperature can be obtained
directly through the use of an S5 sensor.
One or two relays will cut the required functions in and out – the
application determines which:
• Refrigeration (compressor or solenoid valve)
• Defrost
• Alarm
• Refrigeration 2 (compressor 2
)
The different applications are described on next page.
Advantages
• Integrated refrigeration-technical functions
• Defrost on demand in 1:1 systems
• Buttons and seal imbedded in the front
• IP65 density from the front panel
• Can control two compressors
• Digital input for either:
- Door alarm
- Defrost start
- Start/stop of regulation
- Night operation
• Instant programming via programming key
• HACCP
Factory calibration that will guarantee a better measuring accu
-
racy than stated in the standard EN 441-13 without subsequent
calibration (Pt 1000 ohm sensor)
The series
There are three controllers in the series:
A-model for simple regulation
B-model where an alarm function and possibly also a digital input
will be required
C-model where the defrost temperature also enjoys top priority
All these three controllers are without data communication.
If data communication or additional functions are required, we
refer you to the EKC 202 or EKC 204A series.
Comentarios a estos manuales