Danfoss VLT 8000 AQUA Instrucciones de operaciones descargar pdf (Pagina 177)

VLT

8000 AQUA

All about VLT 8000

AQUA

Automatic Motor Adaptation completed

(AMA STOP)

Automatic motor adaptation has ben completed.

The frequency converter is now ready for operation

after the Reset signal has been enabled. Please

note that the motor will start after the frequency

converter has received the Reset signal.

Stand by (STANDBY)

The frequency converter is able to start the motor

when a start command is received.

Stop (STOP)

The motor has been stopped via a stop signal

from a digital input, [OFF/STOP]-buttom or

serial communication.

DC stop (DC STOP)

The DC brake in parameter 114-116 has been enabled.

DRIVE ready (UN. REA DY)

The frequency converter is ready for operation, but

terminal 27 is a logic "0" and/or a Coasting command

has been received via the serial communication.

Not ready (NOT READY)

The frequency converter is not ready for operation,

because of a trip or because OFF1, OFF2

or OFF3 is a logic ‘0’.

Start disabled (STA RT IN.)

This status will only be displayed if, in parameter

599 Statemachine, Profidrive [1] has been selected

and OFF2 or OFF3 is a logic ‘0’.

Exceptions XXXX (EXCEPTIONS XXXX)

The microprocessor of the control card has stopped

and the frequency converter is out of operation.

The cause may be noise on the mains, motor

or control cables, leading to a stop of the

control card microprocessor.

Check for EMC-correct connection of these cables.

MG.83.A2.02 - VLT is a registered Danfoss trademark

175

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 209 210

Sin comentarios

Danfoss VLT 8000 AQUA Instrucciones de operaciones Pagina 177