Danfoss ECtemp 535 Manual de instalación descargar pdf (Pagina 8)

Notice:

The ﬂoor temperature is measured where the sensor is

placed. The temperature of the bottom of a wooden ﬂoor

can be up to 10 degrees higher than the top. Floor manu-

factures often specify the max. temperature on the top

surface of the ﬂoor.

Please contact your ﬂoor supplier for maximum surface

temperature.

Maximum ﬂoor temperature.

When selecting either ﬂoor

sensor or ﬂoor and room

sensors, next screen is maximum

ﬂoor temperature.

Default setting is 35°C.

To change this setting, press • and

use the arrow buttons ▲▼ to select

your choice. Press • to accept your

choice.

If you have selected a combination of

room and ﬂoor sensor, the installa-

tion procedure is complete.

Press installation button to accept.

(Go to page 9)

If you have selected ﬂoor sensor only

press ▲▼ for the next setting.

Conﬁguration - Max. ﬂoor temp.

When the thermostat is used to control a ﬂoor heating

element according to EN/IEC 60335-1 and

EN/IEC 60335-2-96, always use the ﬂoor sensor

and never set the temperature limit above 35°C.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

Danfoss ECtemp 535 Manual de instalación Pagina 8